In tech terminology, you maintain a constant QP (quantization parameter). Typically you would achieve constant quality by compressing every frame of the same type the same amount, that is, throwing away the same (relative) amount of information. CRF versus Constant QPĬRF is a “constant quality” encoding mode, as opposed to constant bitrate (CBR).

You can clearly see the logarithmic relationship between CRF and bitrate. For other CRFs and resolutions, the rates vary accordingly. To give you an estimation of the bitrates to be expected for clips with different resolutions, here’s a figure showing the average bitrate in MBit/s for four one-minute video clips with different encoding complexity, encoded with x264 and different CRF values:Īs you can see, the maximum rate can range between 10 and 25 MBit/s for a 2160p encode at CRF 23. In video streaming, for example, CRF can be used in a constrained/capped mode to prevent bitrate spikes. For other applications, other rate control modes are recommended. You should use CRF encoding primarly for offline file storage, in order to achieve the most optimal encodes. A change of ☖ should result in about half/double the file size, although your results might vary. Is the file size too high? Choose a higher CRF.

Is the quality good enough? No? Then set a lower CRF. If you’re unsure about what CRF to use, begin with the default and change it according to your subjective impression of the output. Ffmpeg -i input.mp4 -c:v libvpx-vp9 -crf 31 -b:v 0 output.mkv

Vsdc vs shotcut